• Tweet

• Tweet

Check it: Tony Buser has made a collection of Met Heads for everyone to use in making mashups.

Notice Tony’s 7-step path to success:

Step 1: Sit in a spinnable office chair

Step 2: setup kinect and reconstructme so only your upper body is inside the scan area.

Step 3: slowly, slowly, spin spin yourself around in the chair while keeping your upper body in a static position

Step 4: load the reconstructme stl into NetFabb, repair it to make it solid, rotate it so it’s right side up, then slice off the bottom to make bottom flat

Step 5: OPTIONAL: Load stl into Meshlab and run filter -> Point Sets -> Poisson Reconstruction, set octree depth to 12 (this results in a smoother model)

Step 6: Load stl into replicatorg, resize, center, place on table

Step 7: …

Step 8: PROFIT!