USB and SD Card Holders
USB memory stick holder by jpcw
To date my solution for organizing extra USB memory sticks and SD flash cards has been to toss them into a drawer. Thingiverse user jpcw’s solution is so much more elegant – a block with carefully designed notches for holding USB memory cards and another block with equally carefully designed notches for holding SD flash cards. Much like the tool holders for hex keys, screwdrivers, and wrenches, it is now possible to hang your SD cards right off of the side of your MakerBot. Nice!
This is a simple USB memory stick holder that holds up to 5 memory sticks. It should fit most size memory sticks and print fairly well without a raft.
This thing brought to you by 
This is a simple SD Card holder that holds up to 8 SD cards. The slots are a little tight to stop the cards falling out if you knock over the holder. Very simple design and prints well without a raft on my heated build platform.
I tried using a bit of FeastWatson Prooftint oak wood stain on it and the effect is quite good. I didn’t expect the stain to go very well on the ABS but it comes out really nice
This thing brought to you by
| Tagged with | jpcw, SD Card, sd flash card, thingalert, Thingiverse, usb, usb drive, usb flash drive | Leave a comment |
